ASTM A304 PDF
This standard is issued under the fixed designation A ; the number immediately following the analysis required, ASTM A , dated ______, worm gear. Buy ASTM A SPECIFICATION FOR CARBON AND ALLOY STEEL BARS SUBJECT TO END-QUENCH HARDENABILITY REQUIREMENTS from SAI. ASTM A Standard Specification for Carbon and Alloy Steel Bars Subject to End-Quench Hardenability Requirements.
|Published (Last):||4 September 2010|
|PDF File Size:||11.86 Mb|
|ePub File Size:||13.7 Mb|
|Price:||Free* [*Free Regsitration Required]|
Parts for handling acetic, nitric, and citric acids, organic and inorganic chemicals, dyestuffs, crude and refined oils, etc.
No other units of measurement are included in this standard. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. Cold working increases tensile strength and hardness. It is non-magnetic in the annealed condition and not hardenable by heat treatment.
Awtm end-quench hardenability shall conform to the requirements specified on the purchase order.
ASTM A304 / 304 L:
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Atm out our inventory of steel tubing and piping. The test specimen requirements indicates that, the number and location of test specimens shall be in accordance with the manufacturers standard practice and shall adequately represent the hardenability of each heat, also, all forged or rolled hardenability test specimens must be normalized prior to testing.
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to a3304 its use and application. The resultant weld has good toughness and ductility. Annealing is recommended after forging to maintain maximum corrosion resistance. Because of its lack of magnetism, it is highly desirable for instruments. Both hardness and tensile strength can be increased by cold working, a3044 may cause slight magnetism.
The grain size and end-quench hardenability test methods are presented in details.
Special hardenability limits are also permissible when approved by the purchaser and manufacturer. The fine austenitic grain size requirements of the steel material are presented in a340. It is a good general all-purpose stainless grade.
It is also widely used for architectural trim. Thierry Boehm Photos and Videos By: Link to Active This link axtm always route to the current Active version of the standard.
ASTM A304 Grade 4140H
Water should be used for heavier sections; air for lighter sections. Monday – Friday 8: Click the button below. Click the link below to download a printable PDF reference of seamless and welded pipe data.
The content of this material specification page was compiled from available public sources and authorities on material properties. Although we believe the information to be corrrect, Metal Stock, Inc. It is easily welded by all commercial processes except forge or hammer welding. This specification covers carbon and alloy steel bars subject to end-quench hardenability requirements. The heat analysis shall conform to the requirements as to chemical composition.
Metal Stock, Inc. – Stainless Steel ASTM A / L Info.
It is good in corrosive environments as in paper and chemical industries a3004 cryogenic services and used where corrosion resistance and good mechanical properties are primary requirements. Historical Version s – view previous versions of standard. This abstract is a brief summary of the referenced standard.
The content of this page is for general information only and is not to be used a04 engineering or design. About Us Contact Us Lead is generally reported as a range of 0.
We carry seamless and welded stainless steel and carbon steel pipe. The methods for estimating the hardness value of the material are presented. Method A is the minimum and maximum hardness values at any desired distance, Method B is the minimum and maximum distances at which any desired hardness value occurs, Method C is the two maximum hardness values at two desired distances, Method D is the two minimum hardness values at two desired distances, and Method E is any minimum hardness plus any maximum hardness.
Need A Quick Quote?